SALOON AND HELM
The Flybridge saloon is u-shaped and on a raised plinth for seated outdoor viewing.
The headliner is GRP molded with foam backed vinyl panels and 4 recessed lights.
It comes completed with a varnished Teak table supported by twin pedestals with carpet underneath.
• Flexiteek® flooring is laid through balance of saloon
• An additional settee is located on port side of saloon
• A stereo is built into the cupboard above the bench top
• The electric panel is starboard as you enter the saloon
• The main battery isolating switches are in the cupboard to the port of saloon door.
PORT BATHROOM
The bathroom is located aft of steps into port hull and houses a fully molded unit with GRP hand basin, and separate shower area with seat. Entry to the engine room is at the aft end of shower.
• Sliding variable height shower rose
• Molded non-slip floor
• Single lever shower and basin mixer
• Recessed toilet roll holder, towel rail
• Two waterproof overhead lights
• Large bowl electric toilet to holding tank, with dock and overboard discharge facilities
• Storage area for toiletries
GALLEY
The Flybridge Galley contains:
• Aquaguard® gelcoat bench top with molded sink/drainer, with chrome single lever mixer tap;
• GRP molded galley unit incorporating timber drawers, doors and trims;
• storage cupboards under sink bench finished in white laminate;
• two additional storage cupboards;
• microwave oven recessed behind sink bench;
• 4 utility drawers;
• a propane oven and 4 burner cooktop as standard (if optional genset is fitted, upgradeable to 3 hob electric);
• a top loading rubbish bin/storage locker;
• a secondary galley module which is located aft of main bench and has matching Aquaguard molded benchtop;
• and a combination fridge/freezer, 12v 75 litre capacity.
INTERIOR FINISH
The beautiful interior finishing and carpentry is of the highest quality. All cabinetry is solid Teak, and meticulously handcrafted by highly skilled cabinetmakers. All hardware is chrome with brushed silver finish. There are three standard color schemes available.
ISLAND QUEEN:
• Handcrafted solid Teak cabinetry throughout
• Solid Teak bed and bunkboards
• Hanging lockers in both cabins
• Extra storage above and below in respective cabins
• High quality carpet on cabin sole and up to spray rail
• Vertiface panels from spray rail to hull/deck join
• Vertiface panels on cabin side, forward and aft bulkheads
• Vinyl ceiling panels
• Vertiface panels on cabin dividing bulkhead.
• Oval opening port hole
• 500 x 500mm overhead ventilation hatch
• Overhead cabin lights
• bed head mounted reading lights
PORT FORWARD MASTER CABIN
Double berth:
• Fabric padded curved bed head
• Cupboards either side of bed head
• Seat at forward end of cabin forming step into berth
• molded locker forward of the main bulkhead
STARBOARD FORWARD CABIN
Twin berth cabin:
• 3/4 double berth with single berth below
• Two cupboards with storage above,
• Extra storage under single berth.
TWIN DOUBLE:
PORT AND STARBOARD
FORWARD MASTER CABIN
Double berth “Twin Double”:
• Handcrafted solid Teak cabinetry throughout
• Fabric padded curved bed head and Teak bunkboards
• Each cabin has 2 cupboards & storage cubby-hole above
• Hanging locker to port
• Seat at forward end of cabin forming a step into berth
• High quality carpet on cabin sole and up to spray rail
• Timber capping on spray rail
• Vertiface panels from spray rail to hull/deck join,
• Vertiface panels on cabin side and forward and aft bulkheads,
• Vinyl ceiling panels.
• Vertiface panels on cabin dividing bulkhead.
• Oval opening port hole
• 500x500mm overhead ventilation hatch
• Overhead cabin lights
• Bed head mounted reading lights
